STID with Galaxy Configuration
GCS-HW-0117-SG-RDRWIR-QRG
Page 6 of 10
9.0
STid Reader with Galaxy Configuration
•
5-conductor, 22 AWG, overall shielded max cable distance 500 feet.
•
2-conductor- twisted pair, 22 AWG, max cable distance 500 feet.
•
Reader will require separate power supply if the current draw is over 150 mA.
•
You must common reader P.S. ground to controller ground.
•
Ground the Drain-wire at one end only (at the DRM Board “GND”).
•
Min. Board Requirement: 635-DRM Board (Dual Reader Module) – PN 20-0235-10
•
Refer to the reader manufacturer’s instructions for wiring (manufacturer's specs may supersede Galaxy specs).
IMPORTANT NOTICES
•
STid Readers are configured to only read MIFARE/DESFIRE CSN.
•
PC2 Smart Cards: STid Reader can read the CSN from PC2 smart cards but cannot read the secure area.
•
The STid Reader with Proximity Module (acts as pass-through data) can read 125KHz cards (EM + HID PROX + AWID + IOPROX
+ INDALA), in addition to the 13.56 MHz. MIFARE/DESFIRE.
•
The mobile-enabled (Blue) STid Readers can use
the Green, Yellow, and Blue Mobile ID (Mobile app).
•
Before power is applied, you must connect all accessory and field wiring, and firmly mount the reader to the wall.
•
The tamper switch is an accelerometer and is calibrated upon power up. If the reader is moved after being powered up, the reader
will be in a ‘tamper’ state and will not send the correct 40 -bit Wiegand data but will send 44-bit data to indicate tamper state.
635-DRM Terminal Functions (PN 20-0235-10)
STid Galaxy-Configured Reader
LED
(LED control line)
LED1 Control
D 1
(Data 1)
D 1
VDC
(+12 VDC)
( Do not use for reader power! )
VDC
(to separate p.s.)
GND
(common Reader’s p.s. ground to Controller ground)
GND
(common to controller ground)
D 0
(Data 0)
D 0
