![background image](http://html1.mh-extra.com/html/galaxy/635-drm/635-drm_manual_3221131005.webp)
STID EASYLINE (Pre-Configured)
GCS-HW-0117-SG-RDRWIR-QRG
Page 5 of 10
8.0
STid Easyline Reader
•
5-conductor, 22 AWG, overall shielded max cable distance 500 feet.
•
2-conductor- twisted pair, 22 AWG, max cable distance 500 feet.
•
Reader will require separate power supply if the current draw is over 150 mA.
•
You must common reader P.S. ground to controller ground.
•
Ground the Drain-wire at one end only (at the DRM Board “GND”).
•
Min. Board Requirement: 635-DRM Board (Dual Reader Module) – PN 20-0235-10
•
Refer to the reader manufacturer’s instructions for wiring (manufacturer's specs may supersede Galaxy specs).
IMPORTANT NOTICES
•
Easyline PC2 Readers are configured to only read
STid PC2 encoded smart cards
.
No other smart cards can be read by this reader.
•
The STid Reader with Proximity Module (acts as pass-through data) can read 125KHz cards (EM/ HID PROX/ AWID/ IOPROX/
INDALA), in addition to the 13.56 MHz STid PC2 Smart Cards.
•
Do not mix non-mobile STid Readers with mobile-enabled (Blue) STid Readers in the same system.
•
The mobile-enabled (Blue) STid Readers can only use
the free Green Mobile ID (Mobile app).
•
Before power is applied, you must connect all accessory and field wiring, and firmly mount the reader to the wall.
•
The tamper switch is an accelerometer and is calibrated upon power up. If the reader is moved after being powered up, the reader
will be in a ‘tamper’ state and will not send the correct 26 -bit Wiegand data but will send 30-bit data to indicate tamper state.
635-DRM Terminal Functions (PN 20-0235-10)
STid Easyline Reader
LED
(LED control line)
LED1 Control
D 1
(Data 1)
D 1
VDC
(+12 VDC)
VDC
GND
(common Reader’s p.s. ground to Controller ground)
GND
(common to controller ground)
D 0
(Data 0)
D 0