6. Usage and Maintenance
6.6 Replacing Bulbs
Notes for Bulb Replacement
Do not touch the bulb with any finger during
replacement. Otherwise, the bulb heat may
evaporate your fingerprint and make it condense
on the bulb reflector, reducing the illuminating
brightness.
Check the work conditions of the light after
the bulb is replaced and go to the authorized
GAC Motor's dealer to check the beam in time.
Hint
•
Halogen or LED bulbs are used in the vehicle.
If any LED bulb is damaged, go to the
authorized
GAC
Motor's
dealer
to
replace it.
•
Basically the same methods will be used for
removing or installing the bulbs on the left and
right sides, so that only the removing or
installing for one side halogen bulb will be
described herein.
Caution
Replace the burned-out bulb with a new one of
the same specification only.
=> Refer to
Page
2
05
for bulb specifications.
Warning
Unless you have the expertise about the
operational
process,
safe
operation
specifications and the tools, have your authorized
GAC Motor's dealer replace the bulb.
•
Turn off all lights first. Replace the bulb after it
has cooled down.
•
During operation, pay attention to sharp
components on the combination light housing
in the engine compartment. Be careful to
protect your hands from being scratched.
Procedure of Replacing Bulbs
If you find that any bulb is damaged, replace it
in time. Make the following preparations before
operation:
1. Turn off all lights.
2. Set the ignition switch at the “OFF” position.
3. Check whether the corresponding fuse is
blown. If it is in good conditions, check and
replace the bulb.
273
230
Summary of Contents for GS5
Page 6: ......
