4. INSTALLATION
43
8. Launch the boat and check for water leak-
age around the sensor.
Speed/Temperature sensor
ST-02MSB, ST-02PSB
4.8
Temperature Sen-
sor (option)
Transom mount temperature sensor
T-02MTB
• Fix the cable at a convenient location on the
transom with the cable clamp.
• When the cable is led through the transom
board, make a hole of approx. 17 mm in di-
ameter to pass the connector. After passing
the cable, seal the hole with a sealing com-
pound.
How to mount temperature sensor T-02MTB
Thru-hull mount temperature sensor
T-02MSB, T-03MSB
Select a suitable mounting location consider-
ing the following points:
• Select a mid boat flat position.
• Select a location where the transducer will
not be damaged in trailering, launching,
hauling, and storage.
• Locate away from equipment which gives
off heat.
• Locate away from drain pipes.
• Select a location where vibration is mini-
mal.
T-02MSB
1. Drill a hole of 21 mm in diameter in the
mounting location.
2. Pass the sensor cable through the hole.
3. Pass gasket, washer and locknut onto ca-
ble in that order.
4. Coat the sensor flange with high quality
sealant and then fasten the sensor with
the locknut. (Torque: max. 59N/m)
5. Launch the boat to check for water leak-
age around the sensor.
How to mount temperature sensor T-02MSB
Locknut
123
Face "notch"
toward bow.
Flange nut
51
Brim
φ
77
Coat with
silicone sealant.
Unit: mm
D
5x20
D>50 cm
=
Flush with hull bottom.
Washer
Gasket
φ
21 mm
Coat with
sealant.
Sensor
cable
Locknut
Summary of Contents for FCV-627
Page 1: ...FISH FINDER FCV 627 OPERATOR S MANUAL www furuno com B R I L L GAIN ...
Page 62: ...D 1 ...
Page 63: ...D 2 ...
