Furuno FAR-2827W, Installation Manual

Page: 43 / 156

2. WIRING
2-9
TPYCY-2.5 power cable
Conductor
S = 2.5 mm
φ
= 2.01 mm
2
TPYCY-2.5
Armor
Sheath
φ
=
15.5 mm
TPYCY-2.5 cable, sectional view
1. Remove the left-hand side cover from the antenna unit by unscrew ten bolts (13 mm).
2. Fabricate the cable as below.
25 mm
5 mm
FV5.5-4
Sheath
Armor
Vinyl
sheath
Approx. 170 mm
Fabricating of TPYCY-2.5
3. Unfasten the clamping gland (for power cable) to remove the gasket, flat washers and
cover.
4. Slide the clamping gland, flat washer, gasket and flat washer in that order on to the
cable. (See the figure in below.)
5. Fold back the armor by 5 mm, then put it between washers.
Gasket
Vinyl sheath
Clamping gland
Flat washer
Trim the armor with width of washer (5 mm).
5 mm
5 mm
Clamping gland (for power cable)
6. Run the power cable behind of the terminal board, and then fix it with the clamp.