Furuno FAR-2827W, Installation Manual

Page: 100 / 156

4. INSTALLING OPTIONAL EQUIPMENT
4-14
J4
DVI-RGB
Conversion board
J9
J3 (Connect DVI cable at step 10.)
Fixing the DVI-RGB conversion board
6. Attach the 10-pin connector from J1 on the 03P9229A board to J9 on the DVI-RGB
board.
7. Attach the connector assembly 03-2092 to J4 on the DVI-RGB conversion board.
8. Remove connector housing J615 from the 03P9342 board. Connect the cable from J3
on the 03P9229A board and the cable from J4 on the DVI-RGB conversion board to
J615. After connection, attach J615 to the 03P9342 board.
To connect wires to the connector housing, use the terminal opener (supplied as installation
materials) as shown below.
j
Press downward
k
Insert core
J615 Housing
Terminal opener
RED
YEL
GRN
ORG
1
2
BRN
Connecting wires to the housing
9. Connect the DVI cable to J3 on the DVI-RGB conversion board. Connect the end which
does not have the ferrite core.
10. Pass an RGB cable (local supply) through the cable clamp and connect it to J2 on the
03P9229A board.
11. Pass the DVI cable through the cable clamp, laying the section with copper tape in the
cable clamp.
12. Assemble the processor unit and connect the other end of the DVI cable to DVI-D port.