Furuno FAR-2827W, Installation Manual

Page: 55 / 156

2. WIRING
2-21
7. Flare the outer conductor against the edge of the outer clamp coarsely with the Bendix
brake pliers. (Wind copper tape over the outer clamp to protect its surface.)
Connector
Outer
conductor
Bendix brake plier
8. Trim and file any portion of the outer conductor that protrudes beyond the diameter of
the outer clamp.
Note: Put a piece of cloth into the conductors temporarily so as not to let any particles in
the conductors.
Connector
Coaxial cable
Remove these
projection.
9. Insert the gauge through the inner conductor until it is covered by the outer clamp. Then,
tap the gauge gently with the hammer to position it.
10. Cut the inner conductor along the gauge and file its end.
Connector
Coaxial cable
Remove inner conductor
so 1 mm remains.
Gauge
1 mm
11. Remove the gauge. Remove any burrs with a knife.
12. Assemble (4) through (8) as below.
a) Screw (5) into (6).
b) Attach (8) to (7).
c) Attach (A) to (B), and then screw it into (4).
(B) (A)
(2)
(1)
(3)
(7) (8) (5)
(6)
(4)