Furuno DS-8500, Installation Manual

Page: 33 / 94

2. WIRING
2-3
2.3.2 How to connect the cables
1. Unfasten the four screws on the rear cable clamp, then remove the cable clamp
to reveal the WAGO connector.
2. Unplug the WAGO connector from the display unit.
3. Pass the cable through the cable clamp.
Note: To maintain the IPx5 waterproof rating, the cable must be TTYCSLA-4 (or
equivalent) with a diameter of φ 14.4±0.4 mm.
4. Referring to the interconnection diagram at the back of this manual, connect the
display unit using the WAGO connector inside the unit.
5. Reattach the WAGO connector to the display unit.
6. Slide the cable clamp along the cable towards the display unit, then fasten the four
screws which were removed at step 1. The cable clamp must be oriented as
shown the figure above.
7. Secure the cable to the cable clamp with cable tie(s) (included). The location and
number of cable tie(s) is different, depending on whether the cable assembly
OP05-146-1, OP05-146-2, optional cable protection kit or waterproofing kit is in-
stalled. Refer to the figure below for the correct location and numbers.
In cases where the WAGO connector is connected to the cable before the cable is
passed through the cable clamp, the cable clamp can be adjusted to allow connection.
How to fit the optional waterproofing kit (OP05-139)
The optional waterproofing kit must be fitted at the same time as the cabling is con-
nected to the display unit.
WAGO connector
The cable clamp must be
oriented as shown in this figure.
Cable clamp Cable clamp
Without using the
waterproofing kit (OP05-139)
With using the
waterproofing kit (OP05-139)
Top view of cable clamp
When using the cable
assembly OP05-146-1,
OP05-146-2 or the cable
protection kit (OP05-147)
When using the cable (TTYCSLA-4)
Slot
Slot
Cable
gasket Cable
gasket
Cable tie Cable tie
Cable tie Cable tie
Cable tie Cable tie
Cable clamp Cable clamp Cable clamp Cable clamp Cable clamp Cable clamp
With three cable ties With two cable ties With a single cable tie
Secure the cable gasket also
with a cable tie. Wind cable ties through the slots. Wind a cable tie outside of the
cable clamp.