Technical Support is available from 8am to 5pm (PST) M - F at [email protected].
22
Assembly Stage 4: Connect the Exhaust System
It is required that an exhaust blower (or fume extractor) is connected and operating whenever you run
a job on your laser. A properly installed exhaust blower removes smoke and fumes from the case and
exhausts them to the outside of the building or a fume extractor. You will also need 4” ducting and two
(2) 4” ducting clamps.
1. Position Ducting:
Place your 4” ducting over the Exhaust Port located at the back of the
machine and hold. Secure with 4” ducting clamp.
2. Attach Exhaust Fan:
Secure the other end of the ducting, connected to the machine, to the
exhaust fan. Now repeat the ducting and clamping process on the other side of the exhaust fan,
creating a sequence of machine to ducting to exhaust fan to second ducting. Now plug in the exhaust
fan into the an outlet or power strip.
FROM
HOBBY
SERIES
TO OUTSIDE WINDOW
Figure 3.11
