Technical Support is available from 8am to 5pm (PST) M - F at [email protected].
11
When your Hobby Series arrives, it will require careful unboxing and examination of parts. Follow
these instructions for best results.
SECTION II. UNBOXING YOUR HOBBY SERIES
1. Create a Work Space:
You will need an open, level work space to place your laser cutter. A
solid table with adequate room (the machine’s dimensions are 32” x 20” x 8.75”) for the machine is
recommended. Be sure the workspace is free of fire hazards and is well ventilated. Always have a
fire extinguisher handy in case of emergency.
2. Carefully Open the Top of the Box:
Set the box on a flat space near where you will place
the machine. Open the box carefully from the top. If you use a cutting tool to open the box, be careful
not to allow the cutting edge to touch the machine or any packed accessories. Always use all tools
with caution and only as specified by the manufacturer.
3. Remove “Honeycomb” Cutting Table:
Remove the honeycomb plate from the box and
then remove the bubble wrap surrounding it. Set the honeycomb plate aside for now. Once we have
removed the packed accessories we will insert it into the base of the machine.
4. Remove the Machine from the Box:
Remove any packaging on top of the machine, then
gently lift the machine out of the box, leaving the bottom foam still inside the box. Place on a clean flat
surface such as the table you plan on keeping it. Be aware that the machine is heavy. Find someone
to help you lift it, if needed. The machine should now be flat on your work surface.
5. Remove Accessories:
Nestled in packing foam, inside the interior of the machine, are the
following parts and accessories: a plastic bag with cords and small accessories, the water pump
and the air compressor (if purchased). Inspect these parts to insure they are accounted for and intact.
6. Insert the Honeycomb:
Place the honeycomb into the laser cutter machine body and lay flat.
Be careful not to hit other machine components during this procedure.
7. Inspect the Machine:
Examine your Hobby Series for defects and breakage. If you find any
defects or breakage, contact your sales representative immediately. Have pictures of the damage
ready to share. Your machine is now unboxed.
Unboxing Steps
FRAGILE PARTS!
Be gentle in removing the foam packaging
and accessories. Never pull or force the packaging loose from
the laser cutter. Be particularly aware that the water inlet and
outlet nodes protrude from the tube and are extremely fragile
when unboxing your laser tube.
