Fujitsu TeamPoS 3600 Series, Installation & Maintenance Manual, Page: 75 / 165

Team PoS 3600 Series
Maintenance
D900000338 Issue 3 7-1
Chapter 7. Maintenance
Caution: Confirm that the external power source is 100-240 VAC before
starting the operation. To prevent electrical shock, confirm that the AC cable is
removed from the AC outlet anytime the covers are removed. Be sure to
observe all ESD precautions and power OFF procedures.
7.1 Periodic Maintenance
The following procedures should only be performed by trained personals.
Vacuum all ventilation passageways on the controller and peripherals. Ensure that these
passageways are open and free of dust and other debris that could restrict airflow. Check the Power
Supply Unit fan for proper operation annually. See CMOS settings for typical fan speeds. If fan
speed is below the normal level, the fan should be replaced. Fan speeds can be found under the
hardware monitoring section of the CMOS.
7.1.1 Power ON and OFF Sequence
This section presents the general procedures for powering ON and powering OFF the
Team PoS
3600 Series
controller. The instructions in this section assume that the terminal, operating system
and the application software have been installed. For any additional power-up procedures dictated
by the retail application, refer to the manuals provided with the application software.
Caution: With the exception of USB peripherals, never disconnect or
connect a peripheral while power is on its port. To avoid damage to the
controller and peripherals, when connecting and disconnecting RS232
peripherals from the I/O Board), press the
Team PoS 3600 Series
power
switch in the front of the unit or disconnect AC power.
7.1.1.1 Powering On
1. Make sure all peripherals are securely connected to the controller.
2. Make sure the power cord is plugged into the power source.
3. Press the ON switch.
Note: The procedures in this chapter are intended for authorized service
personnel only.