Fujitsu TeamPoS 3600 Series, Installation & Maintenance Manual

Page: 119 / 165

Team PoS 3600 Series
BIOS
D900000338 Issue 3 9-1
Chapter 9. BIOS Setup Procedures
Caution: Bios settings are critical to the proper operation of the terminal. Only
Default settings should be used unless you are an experienced user and
understand the proper settings and their functions. Abnormal operation of the
terminal may occur if settings are changed from Default
Caution : If a user selected both the User and Supervisor Password to be the
same, then the user will have full BIOS access after entering the said password.
If a motherboard is replaced in the field, it may be necessary to change the date and time
and setup the BIOS for the customer’s configuration. The following information shows the
default screens from the factory.
9.1 Opening CMOS Setup Screen
Turn ON power and press the “Delete” key while the terminal goes through the power on
self test. (POST).
9.1.1
CMOS Settings
If this is a new motherboard it will be necessary to set the date and time before releasing the
terminal to the customer. To change the date and time, select STANDARD CMOS
FEATURES, then input the current date and time. Run “LOAD OPTIMIZED
DEFAULTS” then “SAVE & EXIT SETUP.” Changing other default settings may be
done at this time if the customer has settings other than the default settings listed here.
Changing settings that are not the default or not set for specific customer needs may
adversely affect the operation of the unit.
In most cases, the CMOS default settings are adequate and do not require changing.
Note: The procedures in this chapter are intended for authorized service
personnel only.