Fujitsu TeamPoS 3600 Series, Installation & Maintenance Manual

Page: 74 / 165

Team PoS 3600 Series
General Operations
D900000338 Issue 3 6-2
6.1.3 Powering ON
1. Make sure all peripherals are securely connected to the controller.
2. Make sure the power cord is plugged into the power source.
3.
Press the ON switch.
4. Confirm the power LED is ON and not blinking, indicating the
successful completion of power-up diagnostics.
Any hardware errors detected on power up will appear on the operator display (CRT or LCD).
Note that the Model VF60 two-line alphanumeric display does not display error messages.
6.1.4 Powering OFF
1. Press the ON/OFF switch.
Note : Some peripherals, such as scanners and scales, may be separately
powered.
Note : Depending on the CMOS setting, a momentary depression of the
switch may signal the application to shut the unit down, which could
take a few minutes. If power is not immediately turned off, either wait
for the application to shut the unit down, or keep the switch depressed
for approximately 4 seconds. For proper shutdown procedures, see the
application software documentation.