Fujitsu TeamPoS 3600 Series, Installation & Maintenance Manual

Page: 23 / 165

Team PoS 3600 Series
Site Preparation
D900000338 Issue 3 4-3
4.5 Preparing for Installation:
Before installing equipment, perform the following steps:
•
Move all terminal components, accessories, and cables to the locations specified in
your local site plan.
•
Position the cables according to the site plan. Make sure you have the correct data cable
at each terminal location.
•
Place the optional equipment next to the terminal to which it will be connected.
•
Remove the shipping tape from those components that have been taped.
4.6 Determining Power Requirements
Electrical power to the equipment must comply with all local, state, and national wiring
codes and meet the requirements described here. If you do not have qualified in-house
personnel to ensure that power requirements are met, an electrical contractor familiar with
computer equipment should be hired. This section provides the electrical supply data and
main power cable information to prepare a site for the installation of the
Team PoS 3600
Series
terminal. This product is also designed for IT power systems with phase-to-neutral
voltage of up to 240V.
Before installing the terminal, check the power lines for loads that could cause large
variations in voltage. Electrical devices that use a great deal of power such as air
conditioners, elevators, copying machines and large motors can cause large drops in
voltage. When severe electrical interference occurs, installing radio frequency (RF) filters,
or an isolation transformer, or both may be necessary. If voltage surges caused by lightning
are likely to occur, install an arrester.
Caution: To prevent data loss, do not plug other equipment that can produce
sudden surges (i.e., vacuum cleaners) into the same power circuit
as the terminal.