Fujitsu TeamPoS 3600 Series, Installation & Maintenance Manual

Page: 27 / 165

Team PoS 3600 Series
Site Preparation
D900000338 Issue 3 4-7
4.8 Installation with Other Equipment
In most cases, dedicated AC mains circuits are not required for the
Team PoS 3600 Series
terminal. In rare instances, other electrical equipment sharing power with the terminal may
cause adverse effects on the terminal. When this occurs, electrical isolation may be
required and is the responsibility of the customer or installing contractor.
Terminals at 100-240 volts
The table below details the power requirements for the
Team PoS 3600 Series
controller
unit. Provide 100-240 volts AC, 50/60 Hz, single phase, with the following amperage
requirements:
Property Value or Description
Grounding
The terminals are Class 1 equipment and must be supplied
via a socket outlet which has a protective ground contact
connected to the protective ground of the terminal.
Power system
The terminals are designed for use on a power system with
a grounded neutral, i.e., a TN or TT power system. The
terminals must not be directly connected to a power
system with impedance grounded neutral, i.e., an IT power
system.
Rated voltage and frequency 100 - 240 volts, 50/60 Hz
Rated current 6A max
Operational frequency limits 47 – 63 Hz
Earth leakage current < 1.0 mA
Power dissipation 350 watts
Maximum HRC fuse rating for
external short-circuit protection
10 A / 20 A
Main power cord:
Length
Diameter
Minimum bend radius
3.00 m (9.80 ft.)
8.0 mm (0.30 in.)
10.0 mm (0.40 in.)