Fujitsu PRIMERGY TX140 S2, Upgrade And Maintenance Manual, Page: 141 / 332

TX140 S2
Upgrade and Maintenance Manual 141
Hard disk drives / solid state drives
7.3.5.2 Removing a 3.5-inch HDD module
Ê
Remove the HDD module to be replaced from the server as described in
section
"Removing a 3.5-inch HDD module" on page 138 .
7.3.5.3 Installing a 3.5-inch HDD module
Ê
Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page 134 .
7.3.5.4 Concluding steps
Ê
If applicable, "Installing the HDD bay cover" on page 64
Ê
"Performing a RAID array rebuild" on page 91
7.3.6 Replacing the 3.5-inch HDD SAS backplane
7.3.6.1 Preliminary steps
Ê
"Locating the defective server" on page 43
Ê
"Disabling BitLocker functionality" on page 69
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
If applicable, "Removing the HDD bay cover" on page 55
Ê
Remove all HDD modules from the server as described in section
"Removing 3.5-inch HDD modules" on page 137 .
V
CAUTION!
Ensure that all hard disk drives are uniquely identified so that you can
reinsert them into their original bays after replacing the SAS
backplane.
Field Replaceable Unit
(FRU) Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver