Fujitsu PRIMERGY TX100 S3, Maintenance Manual

Page: 290 / 348

290 Upgrade and Maintenance Manual
TX100 S3
System board and components
●
Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
●
For further safety information, please refer to section "Environmental
protection" in the PRIMERGY TX100 S3 Operating Manual.
●
Ensure to insert the CMOS battery the with the positive pole
facing up!
14.1.1 Required tools
●
Preliminary and concluding steps:
– Phillips PH2 / (+) No. 2 screw driver
●
Main steps: tool-less; recommended: tooth pick
14.1.2 Preliminary steps
Before replacing the CMOS battery, perform the following steps:
Ê
Shut down the server as described in section "Shutting down the server" on
page 42 .
Ê
Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
"Disconnecting power cord" on page 43 .
Ê
Bring the server to its horizontal position.
Ê
Open the side cover as described in section "Removing the side cover" on
page 45 .
Ê
Remove the HDD cage as described in section "Removing the HDD cage"
on page 61 .