30
Operating Manual
RX220
Installing/Removing the Server into/from the Rack
Hardware Installation
4.3.1
Requirements of the Rack
The rack systems of the Fujitsu Siemens Computers (PRIMECENTER Rack,
DataCenter Rack and 19-Inch (Classic) Rack) support fully the installation of the
PRIMERGY server systems. The installation into the at present usual rack
systems of different foreign manufacturers (3rd-Party Rack) is supported to
large part.
To accommodate the ventilation concept and ensure proper ventilation of the
components in the rack, any unused areas must be closed using dummy covers.
Power is supplied via the socket strips available in the rack.
The main features of the rack systems of the Fujitsu Siemens Computers are:
PRIMECENTER Rack
–
Frontally bolted telescopic rails.
The rails are provided with a linear alignment possibility to ensure also an
adjustment to different rack depths.
DataCenter Rack
–
Frontally or laterally bolted telescopic rails (except within the rear left area
where a support angle is used).
Classic (19-Inch) Rack
–
Laterally bolted telescopic rails.
The mounting of the rails in the different racks is described in the next sections.
3rd-Party Rack
Certain boundary conditions are to be fulfilled:
–
Installation dimensions (see the dimensions shown in
figure 2 on page 32
):
1
rack front side
2
rack rear side
A
rack depth (comparison PRIMECENTER Rack 940/1000 mm)
B
rack width (comparison PRIMECENTER Rack 700 mm)
C
clearance of the 19-inch installation level
C1
front 19-inch installation level
C2
rear 19-inch installation level