Fujitsu PRIMERGY CX400 S1, Upgrade And Maintenance Manual

Page: 118 / 210

118 Upgrade and Maintenance Manual
CX400 S1
Hard disk drives / solid state drives
7.3.4 Replacing a 3.5-inch HDD module
V
CAUTION!
●
Only remove an HDD module during operation if the drive is not
currently being accessed. Observe the indicators for the
corresponding HDD modules, see "PRIMERGY CX400 S1 Server
Enclosure Operating manual".
●
Under no circumstances should you remove an HDD module while
the system is in operation if you are not sure that the drive is operated
by a RAID controller and belongs to a disk array that is operating in
RAID level 0, 1, 1E, 10, 5, 50, 6 or 60.
An HDD module can only be replaced during operation in conjunction
with a corresponding RAID configuration.
●
All HDD modules (drives) must be uniquely identified so that they can
be reinstalled in their original mounting locations later. If this is not
done, existing data can be lost.
7.3.4.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Main steps: tool-less
7.3.4.2 Preliminary steps
Only applicable for removing intact HDD modules:
Ê
Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
http://manuals.ts.fujitsu.com
or from the ServerView Suite DVD 2 supplied with your PRIMERGY
server.
Customer Replaceable Units (CRU)
Average task duration: 5 minutes