Fujitsu PRIMERGY CX272 S1, Upgrade And Maintenance Manual

Page: 120 / 234

120 Upgrade and Maintenance Manual
CX272 S1
Expansion cards
6.3.3 Replacing expansion cards
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
6.3.3.1 Preliminary steps
Perform the following steps:
Ê
Locate the desired server node with the ID button.
Ê
"Shutting down the server node" on page 41
Ê
Remove all external cables from the server node.
Ê
"Removing the server node from the Dual Node Cluster Server" on page 42
Ê
"Removing the riser module" on page 68
Ê
"Removing SAS RAID controller" on page 130 (if applicable)
6.3.3.2 Removing an expansion card
Ê
Remove the defective expansion card as described in "Removing expansion
cards" on page 117 .
Ê
If applicable, remove SFP+ transceiver modules from the expansion card,
as described in section
"Removing an SFP+ transceiver module" on
page 108 .
Upgrade and Repair Unit
(URU) Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver