14
Rev. 8.0
A26361-K863-Z102-8-7619
Notes On Safety
Important Notes
Before Setting Up
V
CAUTION!
●
During installation and before operating the device, observe the
instructions on environmental conditions for your device in the section
“Technical Data” on page 8).
●
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the installation site.
Failure to observe these guidelines can lead to physical damage of
the device.
●
Transport the device only in the original packaging or in packaging
which protects it from knocks and jolts.
Installation and Operation
V
CAUTION!
●
If the server is integrated in a (rack) installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
●
The server automatically adjusts to a mains voltage between
100 V - 127 V or 200 V - 240 V. The server may only be put in
operation, if the mains voltage range set on the server corresponds
to the local mains voltage.
●
This device has safety-tested power cables and must only be
connected to a properly grounded power socket.
●
The power button does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, the
power plugs must be removed from the power sockets.
●
No data transmission cable should be connected or disconnected
during a thunderstorm (lightning hazard).
●
Make sure that no objects (such as bracelets or paper clips) fall into
or liquids spill into the device (risk of electric shock or short circuit).
