A26361-K863-Z102-8-7619
Rev. 8.0
109
The Switch Blade
Installing a Switch Blade
Figure 70: Engaging the locking mechanism (a = green touch point)
Ê
Swing up the eject handle (a) of the switch blade (2) until the locking
mechanism of the switch blade engages.
Removing the Switch Blade
The switch blade is removed in the same way as the dummy module (see
“Removing the Dummy Module” on page 106).
V
CAUTION!
Observe the safety information and the information on handling electro-
static-sensitive components in the section “Components With Electro-
static Sensitive Devices” on page 18.
If you remove the switch blade and do not replace it with a new one, you must
insert a dummy module into the empty slot for insure cooling, to comply with the
applicable EMC regulations (regulations on electromagnetic compatibility) and
for fire protection.
Make sure that the dummy module engages in the slot correctly.
