Fujitsu PRIMEPOWER 800, User Manual

Page: 69 / 145

C120-E093-04EN 41
5.2 Panel Operations
5.2.2 Symbol and Command Lists
Figure 5.3 shows the symbol displayed area, and Table 5.2 lists the symbols and their meanings
and descriptions used for the panel operation. When any fault is detected, corresponding symbol
blinks.
Figure 5.3 Symbol Displayed Area
Table 5.3 lists the commands used for the operator panel.
The following commands are used for selected partitions (symbols: 0 to e) or in case of setting
commands for setup.
For details on commands to select a partition, see the Section 5.2.3, "Panel Operation (Example
of Partition Startup)."
Each command issued to select a partition is enabled or disabled depending on the state of the
Mode switch. For details, see the Table 5.4 .
Table 5.2 Symbol List
Symbol Meaning Description
T Temperature Indicates temperature and humidity at the air inlet, and the
room temperature at operation time in the message line. The
indicated value is of that time. If it reached to the predefined
alarm level, the light blinks.
H Humidity
Z AC input Indicates state of the AC input.
∞
Fan Indicates states of the fans under fault conditions.
P Power supply Indicates status of the power supplies under fault conditions.
C System Control
Facility
Displays messages the System Control Facility issued.
S Setup Selects setup functions of the unit.
Alphanumeric
(0 to e)
Partitions Displays partitions available for entering commands.
Note that setting commands should only be performed by a certified service engineer.
! "