78
C120-E093-04EN
CHAPTER 9 System Management Console (SMC)
A backup of the system volume can be created by following the steps below:
1
Login the SMC as the root account.
2
Enter the command below to display the "ok" prompt.
3
Insert the Solaris CD-ROM into the CD-ROM drive.
4
Insert a data cassette into the DAT unit. Make sure the write-protection tab on
the data cassette is set to "Write-enabled."
5
Boot up Solaris in single user mode from the CD-ROM.
6
When a prompt appears, enter the command below to confirm the controller
number ("c0" in c0t0d0) of the disk of the system volume.
After the controller number is confirmed, close the menu as instructed on the screen.
7
When a prompt appears, enter the command below to start the backup. For the
controller number, enter the number confirmed in Procedure 6.
The backup is completed when a prompt appears again.
(The 8G bytes disk drive requires about 2 hours for backup. Backup of the disk drive takes
longer as its capacity increased.)
8
Press the Eject switch on the DAT unit to remove the data cassette. Be sure to
set the write-protection tab on the data cassette to "Write-protected."
9
Press the <STOP>+<A> keys in order to display the "ok" prompt.
SMC# /usr/sbin/shutdown -g0 -y -i0
<Return>
ok
boot cdrom -s
<Return>
#format <Return>
Searching for disks...done
Confirm this number.
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <sfdsk type1.0; ST320420A cyl 39533 alt 2 hd 16 sec 63>
/pci@1f,0/pci@1,1/ide@3/dad@0,0
Specify disk (enter its number):
SMC#
dd if=/dev/rdsk/c0t0d0s2 of=/dev/rmt/0 bs=1024k
<Return>
Summary of Contents for PRIMEPOWER 800
