Fujitsu PRIMEPOWER 800, User Manual

Page: 107 / 145

C120-E093-04EN 79
9.3 Creating Backups
10
Enter the command below to reboot the System Console Software.
When the Login screen of System Console Software appears, the daily operations can be started.
Remove the CD-ROM disk of the Solaris.
9.3.2 Overview of Restoring the SMC's System Volume
This section describes how to restore data from the data cassettes created in previous Section
9.3.1, "Creating Backup of the SMC's System Volume."
The following items are required to restore system volume:
l
The DDS-3, 125 m (410 ft) DAT data cassettes containing backup data of the system volume
l
The Solaris 7 software CD-ROM disk
Or the SOLARIS 8 SOFTWARE (1 OF 2) CD-ROM disk
If the SynfinityDisk carries out duplicated disk operation, to restore, follow the procedure given
in the manual supplied with the SynfinityDisk.
System volume can be restored by following the steps below:
1
Login the SMC as the root account. If Solaris is not active, set to the OBP mode
by pressing the <STOP> + <A> keys or other procedures, then go to step 3
below.
2
Enter the command below to display the "ok" prompt.
3
Insert the Solaris CD-ROM into the CD-ROM drive.
4
Insert the data cassette with the system volume backup into the DAT unit.
Make sure that the write-protection tab on the data cassette is set to "Write-
protected."
5
Boot up the Solaris software in single user mode from the CD-ROM disk.
ok
boot
<Return>
The restoration process described below should only be performed by a certified service
engineer.
SMC# /usr/sbin/shutdown -g0 -y -i0
<Return>
ok
boot cdrom -s
<Return>