128
5.2.2.3 Paper loading and ejection operation (auto loading)
Loading the paper is done automatically.
< Continuous forms loading operation >
After setting continuous forms on the front or rear tractor, press the LOAD button to start loading operation.
When the top of paper reaches the paper sensor (mounted on the card guide) shown in Figure 5.15, the paper
sensor changes from the “no-paper” state to the “paper present” state. Based on this position, the amount of
paper sending is determined so that continuous forms are loaded to top of form position.
< Continuous forms unload operation >
Pressing the LOAD button on the control panel while paper is loaded unloads the continuous forms to the
position where the tractor detection switch changed from the “paper present” state to the “no paper” state or. If 2
pages have unloaded then stop.
< Continuous forms ejection operation >
Holding the pressing the LF/FF button on the control panel while paper is loaded sends the continuous forms
forward. If 1 page has fed then stop.
< Cut sheet loading operation (automatic cut sheet setting operation)>
Operator push against the cut sheet to the feed roller, loading operation begins after 1.5 seconds since the
PSS(Paper set sensor)changes from the “no paper” state to the “paper present” state. Default setting of
CUTLOAD(in set up mode) is AUTO. If its changed to BUTTON pushing button is necessary to load the cut
sheet.
Figure 5.16 Auto loading mechanism
DV roller
PL roll
RTRPE sensor
(at rear tractor)
Front Tractor
Entrance of front
paper path
Nip roller
TOFL/R sensor
(photo reflector)
on the card guide
PSS sensor
(photo reflector)
Nip roller
Entrance of rear
paper path
Front Tractor
RTRPE sensor
(at rear tractor)
DV roller
Summary of Contents for Impact 3650
Page 112: ...112 ...
