110
(6) Carrier unit (Ribbon drive mechanism)
No. Oil Amount
Lubrication
cycle
Location Remarks
1
FL
F
O
Oil felt section
0.6
〜
0.7CC
2
SG
C
O
Surface that RF shaft slides (Carrier)
3
SG
C
O
Teeth of RF shaft etc.
4
SG
C
O
Axis of pulley and gear
5 SG C
O
Surface that RF shaft slides
(Ribbon bracket)
6 SG C
O
Surface that RF shaft slides
(Ribbon bracket)
Figure 4.87 Ribbon drive lubrication
1-FL-F-O
2-SG-C-O
3-SG-C-O
3-SG-C-O
3-SG-C-O
3-SG-C-O
4-SG-C-O
5-SG-C-O
4-SG-C-O
6-SG-C-O
Note
Don’t apply grease too much to the teeth.
If excessive grease disperses, the slide of a
pulley and a rope will occur and It will be
breaking down early.
Note
Don’t apply grease to the pulley.
It causes the slide of a pulley and a rope and
mechanism will be breaking down early.
Note
Don’t apply grease to the axis of planet gear. If friction of
axis is decrease, the movement of RF lever becomes slow.
It will be cause of defect of ribbon feed.
Summary of Contents for Impact 3650
Page 112: ...112 ...
