103
(6) Vertical Alignment (V-ALMNT) adjustment
1. Load the continuous forms paper wider than 356mm (14 inches) from front tractor.
2. Enter adjustment mode.
“
ONLINE”SW + POW ON ,then printing start at “LQ”speed.
3. Check the direction of displacement and adjust the alignment using
SW as follows.
Figure 4.80 adjusting Vertical Alignment
Note
SW is detected when the cartridge turns each side of printing.
So you must start pushing the SW before carriage turning and release the SW after carriage turning.
If the carriage turns two times while pushing SW, adjustment value is added two steps.
Check all lines (left, center, right) and correct adjustment if necessary.
4. Change the printing mode and adjust individually.
All printing mode is as follows.
For change the printing speed press “TEAR OFF” button.
To enter Hi-impact mode press “Hi-impact” button.
Speed mode
LQ CQ DQ HDQ
(Normal) 120cps 240cps 360cps 505cps
Impact mode
Hi-impact 84cps 169cps 254cps 353cps
5. Save and exit the adjustment mode.
Press “ONLINE” button to exit adjustment mode and save new values.
Printing is early
↓
Push “ ” SW
P Printing is late
↓
Push “ ” SW
Summary of Contents for Impact 3650
Page 112: ...112 ...
