4
Warning and Caution
CAUTIONS
Do not store splicer in any area where temperature and humidity are extremely
high. Possible equipment failure may result.
Do not touch protection sleeve or tube-heater during heating or immediately
after completion of heating. These surfaces are very hot and touching may
result in burns.
Do not place the splicer in an unstable or unbalanced position. The splicer may
shift or lose balance, causing the unit to fall. Possible injury or equipment
damage may result.
The splicer is precision adjusted and aligned. Do not allow the unit to receive a
strong shock or impact. Possible equipment failure may result. Use supplied
carrying case for transportation and storage. The carrying case protects the
splicer from damage, moisture, vibration, and shock during storage and
transportation.
Follow the below listed instructions for handling electrodes:
•
Use only specified electrodes.
•
Set the new electrodes in the correct position.
•
Replace the electrodes as a pair.
Failure to follow the above instructions may cause abnormal arc discharge,
resulting in equipment damage or degradation in splicing performance.
Do not use any chemical other than pure alcohol (99% or greater) to clean the
objective lens, V-groove, LEDs, LCD monitor, etc., of the splicer. Otherwise
blurring, discoloration, damage, or deterioration may result.
The splicer requires no lubrication. Oil or grease may degrade the splicing
performance and damage the splicer.
The equipment must be repaired or adjusted by an authorized technician or
engineer. Unauthorized repair may result in fire or electric shock. Should any
problems arise, please contact your nearest sales agency.
!
Summary of Contents for KSP75-FP-005468
Page 2: ......
