FujiFilm FinePix FinePix S9600, Service Manual

Page: 129 / 154

5-3
5. Inspection
FinePix S9100/S9600 Service Manual
Sequemnce Item Mode Preparations for adjustment
(measurement points, subject, other)
Method of adjustment
(VRs, waveforms, required values)
Measuring
equipment and jigs
Measurement points
(VRs, positions)
4
5
6
Resolution check
Focusing check
Manual focusing
check
Command dial
check
Auto mode
LCD-ON
Auto mode
LCD-ON
P mode
LCD-ON
(1) Use a macro resolution
chart as the subject.
(2) Set the camera to Macro
mode.
(3) Press the flash pop-up
button to pop up the
flash.
(4) Set the camera to flash
mode with red-eye
reduction.
(5) Close the pop-up flash.
(6) Set the camera up so that
the chart fills the screen
from corner to corner.
(7) Press the shutter button
to take a picture.
(1) Set the Focus mode
selector switch to MF.
(2) Press the one-push AF
button.
(3) Turn the focusing ring.
(4) Set the Focus mode
selector switch to AF.
(1) Turn the command dial
left and right.
(2) Press the Macro button
once.
Check that the Macro
icon (tulip) appears on
the LCD monitor.
(3) Check that the flash icon
(A) appears on the LCD
monitor.
After checking, lower the
flash unit by 1 cm and
check that “A” appears
when the flash is carefully
released.
(4) Use the “Flash
Command dial”
combination to select
Red-eye reduction mode.
Check that the red-eye
reduction icon appears on
the LCD monitor.
(5) Check that the pop-up
flash closes.
(6) Set the zoom to the
extreme WIDE setting.
(7) Check that the viewfinder
LED changes from green
to orange (during
recording) and then to
green.
(1) Check that the MF icon
remains as displayed.
(2) Check that the camera
focuses and that the
circle in the center of the
screen changes to yellow.
(3) Check that appears
below the circle in the
center of the screen and
that the focus moves.
(4) Check that the MF icon
disappears.
(1) Check that the F**
number in the bottom left
of the monitor screen
changes.
ZJ00525-100