FujiClean CE Series, Manual

Page: 20 / 47

13. Check / Clean Effluent Airlift
Pipe. (Recommended frequency:
Start-up and 1x every 6 months)
Check the observation port in the
airlift line to see if there is
smooth water flow from the
effluent airlift pump. If there is
uneven flow or a disruption in
flow, then clean the airlift pipe
with a cleaning brush.
14. Clean Recirculation Air-lift
Pump (Recommended
frequency: 1x every 6 months)
Excessive biofilm build-up in the
recirculation air-lift pump may
affect the recirculation rate.
Remove the plastic cap on the
air-lift head, clean inside the pipe
with a pipe cleaning brush. Also
clean the recirculation pumpback
line as shown.
15. Refill the chlorinator (if applicable).
Place
refill chlorination tablets in the chlorinator
tube and adjust the dissolve rate by rotating
the bottom cap of the chlorinator.
16. Cleaning Aeration Pipes (Recommended
frequency: 1x every 6 months or as required)
Aeration Pipes should be cleaned if bubbles
are unevenly distributed even after adjusting
the aeration balance or the recirculation flow
rate has increased considerably without
resetting Recirculation Valve (gray valve).
Use hose adaptor supplied by
Fuji Clean USA.
Step 1. Close the Recirculation
Control Valve (grey valve) and the
Effluent Control Valve (white valve).
Step 2. Turn off the blower.
Step 3. Disconnect a barrel union. HINT: Just
unscrew union and pull off air line. Do not
totally disconnect barrel union.
Clean With Hose : (Use for standard cleaning)
Attach adaptor with check valve (provided by
manufacturer) to garden hose and connect
with aeration pipe. Run water from spigot for
1 minute. Repeat for the 2
nd
aeration pipe.
Step 4. Reconnect aeration
pipes, turn on blower and
re-set standard valve settings
see O&M Pro edure #’s
-12)
18