Fujian Xingyi Polishing Machine Co.,Ltd
Manual Of Remote Control Floor Grinder 800-4E
Factory Addresss:NO.C2 ,Area 11 ,AnPing Development Area, Quanzhou ,Fujian province ,China
Postal Code:362200
Tel: +86-595-36792992
Mob: +86-15960788816
Use only Xingyi parts and accessories, For your own safety, The Safety of others and the life of your machines.
41
Note:
1
、
Emergency stop switch is rotating and press, can not pull, or cause any loss,
manufacturers do not give compensation.
2
、
Take out the grinding pads to prevent it drop is lost before transport, resulting in
unnecessary losses.
3
、
Pay attention to the reserve battery power during operation.
4
、
Polishing up and down on the slope surface(slope up to 17 °) or transport should
be careful.
5
、
Please use the winch if it is steep slope. Prohibited to stand at the rear of the
machine.
6
、
When the low battery indicator shows low battery power (when the red light on the
control box), should avoid moving up the ramp along the machine.
7
、
Drive the machine slowly to move down the slope.
8
、
Drive the machine slowly to move up the slope.
9
、
Upward remove along the slope, should be forward the machine slowly.
10
、
Spinning support wheel,pls not spinning to the highest position,in case of the
support wheel fall out and lead to could not aim the hole position well.
11
、
When spinning supporting well, pls remember the grinding plate and the ground
distance at anytime.