Fujian Xingyi Polishing Machine Co.,Ltd
Manual Of Remote Control Floor Grinder 800-4E
Factory Addresss:NO.C2 ,Area 11 ,AnPing Development Area, Quanzhou ,Fujian province ,China
Postal Code:362200
Tel: +86-595-36792992
Mob: +86-15960788816
Use only Xingyi parts and accessories, For your own safety, The Safety of others and the life of your machines.
9
12. Please note that the emergency stop switch can only be pressed or rotated, prohibit upward
pull.
13. Before operation,check the working surface and remove any protrusion to prevent machine
plate and pads from damage.
14. Double check before plug in to make sure the machine working Voltage, HZ is same with input
Voltage and HZ, no lack of phase of input power.(If the machine do not work normally result in the
input power and working power not same, then manufacturers warranty is unavailable.)
15. Connecting with vacuum to achieve dust free working condition.
16. Do not tilt the machine while the machine is still running, otherwise it will cause a personal
threat.
17. After installing the abrasive must keep the grinding plate touch with ground, should adjust the
handle bar to upward position,operator should operate it comfortable.
18. When machine inverter turn to overload protection it means there is something wrong is the
machine(cable us too small or voltage is unstable) , if so please reference the following cable size
which recommend. Or reduce the abrasive pressure(choose the additional to suitable position) when
users keep using the machine when overload lead to damage , it would not allow to guarantee.
19. After few minutes of grinding ,stop to check how much the abrasive using,this behavior could
reduce the economic loose when using wrong polishing pads/
20. Please do not upward the machine when machine is still running , or the polishing pads is
flying out to threat the human safety.
