6 - 2
INP-TN4PHAV-E
6.2
Power switch-on and states
(1) Open the front flap.
(2) The power supply switch is at the above left; switch it on.
(1)
Initial switch-on of power
↓
(A cursor appears in the upper left of the display section.)
↓
The recording head moves slowly to the left-hand end (the 0% side).
↓
When the 0% point is detected, the recording head moves to a position that is
about 50mm from the left-hand end and stops.
↓
The input data and Tag No. are displayed in the display section.
(No recording takes place.)
(2)
If the power is switched off while recording is stopped and switched on again:
The state becomes 'Recording stopped'.
(3)
If the power is switched off during recording operation and switched on again:
The state becomes 'Recording in progress'.
Recording in progress
↓
Power supply cut off
↓
Display disappears
Recording stops
↓
Power turned on again
↓
(Cursor appears in top left of display section)
↓
The recording head moves slowly to the left-hand end (the 0% side).
↓
When the 0% point is detected, the recording head moves to a position that is about 50mm
from the left-hand end (0%), moves back again to the left-hand end and is on standby
↓
The input data is displayed in the display section and recording restarts.
Ch1.
100
°
C
—
—
Ch1.
100
°
C
Record ON
