Fuji Electric PEN102J1C, User Manual

Page: 15 / 85

XIV
•
This device is for AC100,110,120V 50/60Hz. It breaks
down when using it by the voltage excluding this, and it
causes a fire and the electric shock.
•
Do not use the table tap. The tap overheats, and it causes a
fire.
•
Do not use the extension cable. The power cable overheats
when the power cable not suitable for the power supply
specification of this device is used and it causes a fire.
•
Pull wiring from the input distribution panel directly. Use
wiring suitable for the power supply specification of this
device. The wiring overheats when the wiring not suitable
for this is used and it causes a fire
•
Do not tightly bend cables, do not bundle cables, do not put
the one on connected cables. The cable is damaged, and it
causes the electric shock and a fire.
•
The connection of cables must not use it imperfectly. It
causes the electric shock and a fire by the short and heatup.
•
Wet the cable and neither rear connector nor the terminal
stand of this device with water etc. It causes the electric
shock and a fire.
•
Tightening the terminal must not have loosening. It might
cause smoking and the ignition.
•
Select the diameter of wire more than the device ratings
current by the voltage-standing 600V or more.
•
Do not put the foreign body. Internal parts are
short-circuited when foreign bodies of metals and the
combustible one, etc. enter and it causes the electric shock
and a fire. Stop outputting with the turning off button, and
pull out the power cable when the foreign body enters UPS.
•
Do not set up this device in a dusty place. Dust is
accumulated, internal parts are short-circuited, and it causes
the electric shock and a fire.
•
Do not use it in the place where salinity and the causticity
gas are generated. Internal parts are short, deteriorated, and
it causes the electric shock and a fire.
!
•
This device is a heavy load. Work by two people or more
when you carry. work wearing gloves and the safety shoes,
etc. because it doesn't injure.
•
Do not put the container including water on the upper face
of the device.。Might it get an electric shock when falling, and
it cause a fire.
•
Pull out the power cable after stopping outputting at once
by off button of UPS when abnormality is caused while
using this device.
•
Do not get on on this device, and don't put the one. It is likely
to injure by falling, and breaking.
•
Do not set up this device in an unstable place. It is likely to
injure by falling, and breaking.
!