INF-TN2FSC-E
143
(3) Detail setup
Set measuring conditions.
Point the cursor to “DETAILS” by pressing , key, and then press the
ENT
key.
(1) Sensor type
Point the cursor to “SENSOR TYPE” by using the
, key and press the
ENT
key.
Select the type of sensors to be used.
(2) Sensor source
Point the cursor to “SENSOR SOUCE” by using the
, key and press the
ENT
key.
Set connection between the sensor and conversion
unit's connector.
Use the upstream side, normally in case one measur-
ing line. (Sensor U)
In case of two measuring lines, use both of upstream
side and downstream side. (Sensor U/D)
Make selection corresponding to the connection.
(3) Display selection
Point the cursor to “KIND” by using the , key
and press the
ENT
key.
Either fluid velocity or flow rate is displayed together
with flow velocity distribution.
Select the item to be displayed.
