CP-100 • User’s Guide
67
4. Operation
Using the Setup Menu
•
Gain
— This value adjusts the sensitivity of the keyer, enabling you to change the
sharpness of the keyed image. Gain only affects the key hole, as set by the clip.
~
Adjustment range
: 0 to 1023.99
~
Default
: 1.00
•
Opacity
— This value adjusts key opacity.
~
Adjustment range
: 0 (fully opaque) to 1023 (fully transparent)
~
Default
: 1023
•
H Offset
— This value adjusts the key source’s horizontal offset (in pixels), if the
key source’s resolution is greater than (or less than) the output resolution.
•
V Offset
— This value adjusts the key source’s vertical offset (in pixels), if the key
source’s resolution is greater than (or less than) the output resolution.
Refer to the “
” section on page 92 for more information on using keys.
ildl=pÉíìé=jÉåì
A logo is a full-screen video source that, when you transition to it, appears on top of all
other sources. From the
Setup Menu
, select
LOGO Setup
to display the
LOGO Setup
Menu
, which enables you select, save and delete up to three full-screen logos.
Figure 4-34.
LOGO Setup Menu (sample)
Following are descriptions of each
Logo Setup Menu
function:
•
Selection
— This field enables you to select the desired logo.
~
Selections
: LOGO1, LOGO2 and LOGO3
~
Default
: LOGO1
•
[resolution]
— This field shows the current resolution of the saved logo, if the
output resolution matches the resolution at which the logo was captured. The field
shows [
EMPTY
] if nothing has been saved at the selected location, or [
INVALID
[resolution]
]
— e.g. [
INVALID 1600x1200
] — if the logo resolution does not
match the current output resolution.
Because the field is not user selectable, all data is shown between brackets.
Tip
Always select the desired key source and adjust the key
parameters prior to your production. The key must be visible
on program in order to visually adjust clip, gain and opacity.
L O G O S E T U P
> S e l e c t i o n
L O G O 1
[ 1 0 2 4 x 7 6 8 ]
S a v e P g m t o L o g o
D e l e t e L O G O 1
