Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 69 / 112

67
g
Set the shielding gas flow rate:
If there is a "Feeder inching"/"Gas test" button:
-
Press the "Feeder inching" / "Gas test" button upwards and release
- Turn the adjusting screw on the underside of the pressure regulator until the pres-
sure gauge shows the required gas flow rate
- Press the "Feeder inching" / "Gas test" button upwards again and release
If there is no "Feeder inching"/"Gas test" button:
-
Press the "Mode" button to select 4-step mode
- Set the "Ito" parameter to "Off" in the set-up menu
- Disengage the feed rollers
- press the torch trigger briefly
- turn the adjusting screw on the underside of the pressure regulator until the pres-
sure gauge shows the required shielding gas flow rate
- press the torch trigger again briefly
- engage the feed rollers
Press the torch trigger and start welding
Corrections dur-
ing welding To obtain the best possible welding results, the dynamic welding parameter will sometimes
need to be adjusted.
Press the "Parameter selection" button to select the dynamic welding parameter
Use the adjusting dial to set the desired dynamic value
The welding parameter value is shown in the digital display located above it.
Dynamic
for influencing the short-circuiting dynamic at the moment of droplet transfer
0 harder, more stable arc
10 soft, low-spatter arc
CAUTION! Risk of injury and damage from electric shock and from the wire
electrode emerging from the torch. When pressing the torch trigger:
- keep the welding torch away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any electrically
conducting or earthed (grounded) parts, such as the housing, etc.
CAUTION! Risk of injury and damage from electric shock and from the wire
electrode emerging from the torch. When pressing the torch trigger:
- keep the welding torch away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any electrically
conducting or earthed (grounded) parts, such as the housing, etc.
8
9
1
2