Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 34 / 112

32
(6) "Process" button
for selecting the welding process
MANUAL - MIG/MAG standard manual welding
SYNERGIC - MIG/MAG standard synergic welding
STICK - MMA welding
(7) "Mode" button
for selecting the mode
2 T - 2-step mode
4 T - 4-step mode
S 4 T - Special 4-step mode
(8) "Protective gas shield" button
For selecting the shielding gas to be used. The SP parameter is intended for addi-
tional shielding gases.
When a shielding gas is selected, the LED behind the relevant shielding gas lights
up.
(9) "Wire diameter" button
For selecting the wire diameter to be used. The SP parameter is intended for addi-
tional wire diameters.
When a wire diameter is selected, the LED behind the relevant wire diameter lights
up.
(10) "Material" button
For selecting the filler metal to be used. The SP parameter is intended for addition-
al filler metals.
When a material is selected, the LED behind the relevant filler metal lights up.
(11) Intermediate arc indicator
A spatter-prone intermediate arc forms between the short circuit arc and the spray
arc. The intermediate arc indicator lights up to alert you to this critical area.
(12) HOLD indicator
Whenever welding stops, the actual values for welding current and welding voltage
are stored, and the “Hold” indicator lights up.
Service parame-
ters Various service parameters can be retrieved by pressing the "Parameter selection" buttons
at the same time.
Opening the display
The first "firmware version" parameter is displayed, e.g. "1.00 | 4.21"
Selecting parameters
Press and hold the "Parameter selection" button (left)
Press the "Parameter Selection" button (right)
Release the "Parameter selection" buttons
1
2
3