Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 66 / 112

64
MIG/MAG standard Synergic welding
MIG/MAG stand-
ard synergic
welding Press the "Material" button to select the filler metal to be used.
Assignment of the SP position depends on the welding database used for the power
source.
Press the "Wire diameter" button to select the diameter of the wire electrode to be
used.
Assignment of the SP position depends on the welding database used for the power
source.
Press the "Protective gas shield" button to select the shielding gas to be used.
Assignment of the SP position depends on the welding database used for the power
source.
Press the "Process" button to select the desired welding process:
MIG/MAG standard synergic welding
Press the "Mode" button to select the desired MIG/MAG mode:
2-step mode
4-step mode
Special 4-step mode
Press the "Parameter selection" buttons to select the welding parameters to be used
to specify the welding power:
Sheet thickness
Welding current
Wire feed speed
Welding voltage
Use the appropriate adjusting dial to set the relevant welding parameters.
The welding parameter values are shown in the digital display located above them.
All welding parameter set values remain stored until the next time they are changed. This
applies even if the power source is switched off and on again in the meantime.
To display the actual welding current during welding:
-
Press the "Parameter selection" button to select the welding current parameter
- The actual welding current is shown in the digital display during welding.
Open the gas cylinder valve
Set the shielding gas flow rate:
IMPORTANT! Under certain circumstances, welding parameters that have been set
on a system component control panel (TR 2000 and TR 3000 remote control units or
robot interface) may not be changed on the control panel of the power source.
1
2
3
4
5
6
7
8
9