Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 58 / 112

56
Start-up
General
The device is started up by pressing the torch trigger (for manual applications).
Prerequisites The following conditions must be satisfied before the device is started:
-
Welding torch connected
- Feed rollers inserted
- Wirespool or basket-type spool with adapter inserted
- Wire electrode fed in
- Brake adjusted
- Feed roller contact pressure set
- All covers closed, all side panels in place, all protection devices intact and in their
proper place
- Where applicable, water connections connected
Starting up Before proceeding further as described in the "Welding mode" section, the following activ-
ities are required for "MIG/MAG standard synergic welding" and "MIG/MAG standard man-
ual welding":
Plug in the mains plug
Turn the mains switch to the "I" position
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
1
2