Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 17 / 112

15
g
Danger from
shielding gas cyl-
inders
Safety measures
at the installation
location and dur-
ing transport
If the wire-feed unit is attached to a crane holder during welding, always use
a suitable, insulated wire-feed unit holder (MIG/MAG and TIG devices).
If the device has a carrying strap or handle, this is intended solely for carrying
by hand. The carrying strap is not to be used if transporting with a crane, fork-
lift or other mechanical hoist.
Odourless and colourless shielding gas may escape unnoticed if an adapter
is used for the shielding gas connection. Prior to assembly, seal the device-
side thread of the shielding gas connection using suitable Teflon tape.
Shielding gas cylinders contain gas under pressure and can explode if dam-
aged. As the shielding gas cylinders are part of the welding equipment, they
must be handled with the greatest of care.
Protect shielding gas cylinders containing compressed gas from excessive
heat, mechanical impact, slag, naked flames, sparks and arcs.
Mount the shielding gas cylinders vertically and secure according to instruc-
tions to prevent them falling over.
Keep the shielding gas cylinders well away from any welding or other electrical
circuits.
Never hang a welding torch on a shielding gas cylinder.
Never touch a shielding gas cylinder with an electrode.
Risk of explosion - never attempt to weld a pressurised shielding gas cylinder.
Only use shielding gas cylinders suitable for the application in hand, along with
the correct and appropriate accessories (regulator, hoses and fittings). Only
use shielding gas cylinders and accessories that are in good condition.
Turn your face to one side when opening the valve of a shielding gas cylinder.
Close the shielding gas cylinder valve if no welding is taking place.
If the shielding gas cylinder is not connected, leave the valve cap in place on
the cylinder.
The manufacturer's instructions must be observed as well as applicable na-
tional and international regulations for shielding gas cylinders and accesso-
ries.
A device that topples over can easily kill someone. Place the device on a solid,
level surface in such a way that it remains stable
-
The maximum permissible slope is 10°.
Special regulations apply in rooms at risk of fire or explosion
-
observe relevant national and international requirements.