Fronius TRANS STEEL 3500 C0MPACT, Operating Instructions And Spare Parts List

Page: 54 / 112

52
Set the "Ito" parameter to "Off" in the set-up menu
IMPORTANT If the torch trigger is pressed instead of the "Feeder inching"/"Gas test" but-
ton, the welding wire runs at the feeder creep speed (depending on the welding program)
for the first 3 seconds. After these 3 seconds, wirefeeding is briefly interrupted.
The welding system detects that the welding process should not start, but that the wire is
to be fed in. At the same time, the shielding gas solenoid valve closes, and the welding
voltage on the wire electrode is switched off.
If the torch trigger is kept pressed, wire feeding restarts immediately without shielding gas
and welding voltage, and the process continues as described above.
Set the contact
pressure
CAUTION! Risk of injury and damage from electric shock and from the wire elec-
trode emerging from the torch. When pressing the torch trigger:
-
keep the welding torch away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any conductive or earthed
(grounded) parts, such as the housing, etc.
2
2
4
5
3
1
3
1
1
2
3
4
NOTE! Set the contact pressure in such a way that the wire electrode is not de-
formed but nevertheless ensures proper wirefeed.
1
1