Fronius Cleaning Unit TC 2000, Operating Instructions Manual

Page: 8 / 68

8
Environmental
Conditions
Obligations of the
Operating Com-
pany
Obligations of
Personnel
Particular hazard
areas
Operation or storage of the device outside the stipulated area will be deemed
as not in accordance with the intended purpose. The manufacturer is not re-
sponsible for any damage resulting from improper use.
Temperature range of the ambient air:
-
During operation: 0°C to + 40°C (32°F to 104°F)
- During transport and storage: -25°C to +55°C (-13°F to 131°F)
Relative humidity:
-
Up to 50% at 40°C (104°F)
- Up to 90% at 20°C (68°F)
Ambient air: free of dust, acids, corrosive gases or substances, etc.
Altitude above sea level: up to 2000 m (6500 ft.)
The operating company must only allow persons to work with the device if they
-
Are familiar with the basic occupational safety and accident prevention
regulations and are trained in handling the device
- Have read and understood these Operating Instructions, especially the
section "Safety Rules," and have confirmed this with their signature
- Are trained according to the requirements for the work results
The safety-conscious work of the personnel must be checked regularly.
All persons who are assigned to work with the device must do the following
before beginning the work:
-
Follow the basic regulations for occupational safety and accident preven-
tion
- Read these Operating Instructions, especially the section "Safety Rules,"
and confirm that they have understood and will follow them by signing
Before leaving the workplace, ensure that no personal injury or property dam-
age can occur in one's absence.
Do not linger in the operating area of the robot.
Always integrate the device into a higher-level safety system in a secured ar-
ea.
If this area has to be accessed for preparatory or maintenance work, ensure
that
-
the entire system is shut down for the duration of access to this area
- and remains shut down to prevent unintended operation, e.g., as a result
of a control error
In addition to these Operating Instructions, the safety rules of the robot man-
ufacturer must be followed.
Covers and side parts must only be opened/removed during maintenance and
repair work.
During operation:
-
Ensure that all covers are closed and all side parts have been mounted
properly.
- Keep all covers and side parts closed.