Fronius Acerios, Operating Instructions Manual

Page: 49 / 84

Job Retrieval
NOTE!
Before retrieving a job, make sure that the plasma power source is set up and
installed in accordance with the job.
1
Press the operating mode button to select Job Mode
The last used job is displayed.
2
Use the selection dial to select the desired job
Use the left and right parameter selection buttons to view the settings pro-
grammed in the job. It is not possible to change these settings.
It is not possible to select unassigned program locations (indicated by "- - -")
either, when retrieving a job on the plasma power source.
3
Start the plasma process
The plasma surface treatment is performed with the parameters saved in the
job. During the plasma process, it is possible to switch to a different job
without interruption.
Switching to a different operating mode ends Job Mode.
49
EN-US