11.
Ensure that the tenon joint of the threaded spindle (where the
pressure piece was previously affixed) is sitting in the bore hole
provided in the pressure plate (b).
12.
Push the Safe-Lock tensioning device so that the mounting of the
grinding bowl holder sits centrally in the U-shaped cut-out of the
longer projection.
13.
Pre-tension the setting screw (e) manually, and screw it tight using
the provided torque spanner. Place the torque spanner provided
on the setting screw (b) and turn until it clicks. (2.6 Nm)
14.
Then press the clamping lever downwards.
15.
Wait a few seconds. Release the Safe-Lock again and turn the set-
ting screw (e) again using the torque spanner until it clicks.
16.
Press the clamping lever downwards again.
Accessories
- 48 -
