CAUTION!
The emergency release must not be activated while the
machine is running! Disconnect the machine from the
mains before the emergency release. Failure to observe
this will render void the guarantee, and releases us
from liability for any resulting damage to the device or
personal injury.
1.
Insert the included triangular key (A) into the bore hole on the
bottom side of the PULVERISETTE 5 classic line and turn it clock-
wise 180 degrees.
2.
Unlock the latch (2) by pressing the hood handle (1).
3.
The hood (3) can now be opened.
4.
The mill can only be switched on again if the hood (3) is closed and
the safety lock (7) has been reactivated by turning the triangular
key 180 degrees anticlockwise.
2.6.2 Imbalance check
The device switches off if there is excessive imbalance. (See Chapter
Chapter 6.6 „Mass balance“ on page 39)
CAUTION!
The imbalance check can be disabled at your own risk.
Fritsch assumes no liability for damage resulting from
the deactivation of the imbalance check!
NOTICE!
Change these settings only after all work as described in
Chapter 4 „Installation“ on page 20 has been car-
ried out!
NOTICE!
The highest level of sensitivity is set for the imbalance
check as the factory default. In order to adjust the
imbalance check to suit your applications as best as
possible, set the value for the imbalance check as
explained in Chapter
imbalance check“ on page 24. Please note that you
have to redefine this setting for various parameters
with different grinding sets and balls.
Safety information and use
- 15 -
