4.6 Fastening the Cross beater mill to the universal support stand
Setting up the universal support stand is described in
chapter
Chapter 7.2 ‘Universal support stand’
1.
Position the PULVERISETTE 16 on the universal support stand.
Ensure that the larger section of the stand is facing forward.
CAUTION!
Hazard of tipping!
Secure the device against tipping until it is com-
pletely screwed down, as the centre of gravity
allows the mill to tip forwards.
2.
Attach the device to the stand with the attachment kit provided.
3.
Place both bars with threaded bore holes into the U-beams sitting
on the mounting plate. Take one spring ring and one washer for
each of the screws and screw the device to the universal support
stand from below.
4.7 Electrical connection
DANGER!
Provide short-circuit protection!
Risk of damage due to short-circuits.
– Make sure that the socket is connected to a mains
line protected with a residual current circuit
breaker.
CAUTION!
Ignoring the values on the type plate may result in
damage to the electrical and mechanical components.
Before establishing the connection, compare the voltage and current
values stated on the type plate with the values of the mains system to be
Chapter 3 ‘Technical data’ on page 14)
n
Connect the Cross beater mill to the electrical outlet using the sup-
plied connecting cable.
n
External fuse protection is to be provided for the connection of the
mains cable to the mains according to the regulations at the installa-
tion site.
Installation
- 18 -
