6.3.3 Inserting the cross beater
n
Slide the cross beater (5) onto the motor shaft (11) and align it by
pressing the feather key until the safety ring clicks into the groove on
the motor shaft.
After this step you may close the device.
To remove the grinding elements, follow the steps in
reverse order.
6.3.4 Inserting filter unit and collecting vessel
When using a collective vessel without a filter unit, the
release of dust from the funnel must be expected.
Therefore never operate the PULVERISETTE 16 without
a filter hose.
3
Filter hose
3.1 Filter hose lock
4
Collecting vessel
4.1 Collecting vessel lock
Using a filter hose ensures that the air stream created
by the impact rotor discharges downwards to the mate‐
rial output. In addition, the material throughput is
increased and the separation of the solid matter in the
air stream is ensured.
1.
Slide the filter hose (3) over the flange while holding the locks (3.1)
at an angle.
2.
Tighten these locks (3.1).
3.
Mount the collecting vessel (4) while holding the locks (4.1) at an
angle.
4.
Tighten these locks (4.1).
Using the device
- 25 -
