39 - ENGLISH
7.2 EXTRAORDINARY MAINTENANCE (INTENDED FOR QUALIFIED PERSONNEL)
These operations are reserved exclusively for authorised qualified personnel. FRIGOMAT
S.r.l. will not be held liable for damage to objects or harm to persons which occur due to
failure to comply with the above.
Refer to the following instructions to program the circuit board:
1. Make sure that the door is assembled on the
machine.
2. Power the machine.
3. With the machine at STOP, press the “
STOP
”
and “
PRODUCTION
” keys simultaneously and
release
them
only
after
the
password
identification screen appears (fig.1).
4. Press the “
CREATIVE
(
Ÿ
)” “
PRESERVATION
(
ź
)” and “
PRODUCTION
(
ŻŹ
)” keys to enter
the password and then confirm it (fig.2). If you
do not know the password, contact the
Frigomat assistance service.
5. When the password has been accepted, the
screen accesses the list of programming steps
directly. The first programming step
P01
is
selected automatically.
6. If you do not wish to change the value of the
selected step, press “
CREATIVE
(
Ÿ
)” to
directly access the following step (Fig. 3).
7. If, instead, you wish to change the selected
step, press “
PRODUCTION
(
ŻŹ
)” to access
the parameters relative to the same step, and
subsequently press “
CREATIVE
(
Ÿ
)” or
“
PRESERVATION
(
ź
)” to increase or decrease
the value (fig.4). Subsequently, press the
“
PRODUCTION
(
ŻŹ
)” key to confirm the data.
8. To exit programming and save the changed
press the "
STOP
" key.
Fig.4
Fig.1
Fig.2
Fig.3
Summary of Contents for KISS 3 POWER Series
Page 47: ...ENGLISH 46 ...